To help customer to develop higher quality and lower cost product during the product design phase, we provide highly knowledgeable and experienced engineers for providing value-add engineering DFX support services to customer.
Free DFX service is provided for every PCBA prototype build in Sparqtron.
Thoroughly review of customers design including FAB circuit/trace routing, component positioning and spacing, potential fault reduction and process selection, and provide recommendations to enhance customer’s design, such as circuit design, mechanical design, etc. This service helps to reach the smooth and efficient manufacturing at the early stage of volume production.
A complete review of the circuit design and trace routing to increase test accessibility and device testability so to increase the overall coverage over Flying Probe Test and In-Circuit-Test for achieving the lowest possible risk and best product yield rate in the volume production stage.
DFX report will be provided to customer for each new PCBA assembly job with Sparqtron. Our review will cover the following categories:
We will provide design Review Suggestions as blow:
We work hand in hand with customer's engineering staff to provide prompt feedback and solutions to improve the design and manufacturing process.
Service offering Summary: Free DFM / DFT/ DFX, Engineering Support Services, Design Review Suggestions
We are located in Bay Area, Silicon Valley, California, USA. (nearby San Jose)
Sparqtron Corportation Tel: 1-510-657-7198 EXT. 200,    firstname.lastname@example.org
Address: 5079 Brandin Court, Fremont, California CA 94538, USA
(San Francisco Bay Area, near San Jose)